Suporte ao otimizador de energia Guia do usuário do Page_Smart Module Optimizer | FusionSolar Brasil

Controlador de módulo
inteligente

SUN2000-450W-P2 / SUN2000-600W-P

Ficha de dados 6.34 MB

Manual do usuário 635.59 KB

Guia rápido 2.9 MB

White Paper 6.94 MB

Baixe mais

Vídeo de instalação

Perguntas frequentes

Disconnection Detection
Rapid Shutdown
Replacing an Optimizer
Checking the PV string resistance

Perform disconnection detection on optimizers and locate the disconnected ones.

Method 1: Disconnection Detection on the FusionSolar App  >

Method 2: Disconnection Detection on the WebUI of the FusionSolar SmartPVMS  >

Method 3: Disconnection Detection on the Local Device Commissioning Screen  >
When the output is disconnected or the inverter shuts down, the optimizer can adjust the module output voltage to a safe range to ensure the safety of the construction and O&M personnel as well as firefighters.

Method 1: Turn off the AC switch between the inverter and the power grid.  >

Method 2: Turn off the DC switch on the inverter.  >

Method 3: Connect a switch to the DI and GND ports of the inverter to form a circuit. (For details about which DI port is used, see the corresponding inverter user manual.) The switch is turned on by default. Turn off the switch to trigger a rapid shutdown.  >
Replacing an Optimizer (on the FusionSolar App) >

Replacing an Optimizer (on the Local Device Commissioning Screen) >
Checking the PV string resistance >

Disconnection Detection

Method 1: Disconnection Detection on the FusionSolar App   Click to view   >

Method 2: Disconnection Detection on the WebUI of the FusionSolar SmartPVMS   Click to view   >

Method 3: Disconnection Detection on the Local Device Commissioning Screen   Click to view   >
Rapid Shutdown

When the output is disconnected or the inverter shuts down, the optimizer can adjust the module output voltage to a safe range to ensure the safety of the construction and O&M personnel as well as firefighters. Click to view >
Replacing an Optimizer

1.Replacing an Optimizer (on the FusionSolar App) Click to view >

2. Replacing an Optimizer (on the Local Device Commissioning Screen) Click to view >
Checking the PV string resistance

Checking the PV string resistance Click to view >

The measured PV string resistance must meet the following requirement: PV string resistance (R1 + R2)/2 kΩ ≈ N x 1 kΩ. For example, if there are 16 optimizers in a PV string, the PV string resistance should be about 16 kΩ. If the measured PV string resistance is abnormal, rectify the fault by referring to this section. Click to view >

Comunidade

Saber mais

Ferramentas de projeto

Saber mais

主页